MIP X-Duty CVD Kit for Traxxas Bandit

This is a MIP Rear X-Duty CVD Drive Kit for the Traxxas Bandit.

Features:

• Strong splined X-Duty steel construction
• Strong 12mm Keyed Hex Standard (Must use 12mm wheels not compatible with pin)
• Fully rebuildable so any damaged or worn part can be replaced. (scroll down on main part # and all rebuild components are there)
• Ultimate upgrade for those that are drag racing!
• No more ripped and twisted drivetrain.
• Heat Treated steel components to help increase strength and part life
• Black Oxide coated to protect the components from premature rust
• 100% Designed / Manufactured / Packaged in the USA

Includes:

• (1) MIP Inst. Sheet, Traxxas Bandit
• (1) MIP Thread Gel Safety Sheet
• (1) MIP Support Parts Insert Sheet
• (1) MIP Lube & Thread Gel Cup
• (2) MIP Confetti Sticker
• (2) CVD Axles/Traxxas Slash Duty Rear
• (2) MIP X-Duty Female Bone, 40mm
• (2) MIP X-Duty, Drive Hub, 13mm with 5mm Bore
• (2) MIP X-Duty Male Bone, 42mm
• (2) shss, M3 x 4mm Flat Point
• (2) Hex Adapter Traxxas X-Duty CVD Kit
• (4) MIP M4 Pin Screw Slash Diff
• (4) MIP Bearing Spacer, Rear, Traxxas Slash, Slash 4x4
• (2) spacer, HPI Blitz ft. bearing spacer
• (5) MIP 1/4" CVD Coupling
• (5) 0.092 x .625 Cross Pin with flat
• (5) shss, 8-32 x 1/8 flat point
• (2) nut, m4x.7 steel nyloc

Notes:

• When hubs are in the lowest position, clearance on the arm may be necessary for the X-Duty Bell to rotate freely. Best to use a sanding drum to clearance the plastic arm. (check out photo with wrench pointing to area)
• Use MIP Grease and Loctite upon assembly.
• Be sure to keep joints lubed to enjoy long part life
• Front Traxxas 12mm Hex Conversion: (1) TRA1654
• Upgrade Hubs and Bearings recommended: TRA3752 , TRA5116