This is the EcoPower "Electron" 3S 5000mAh, 50C Lithium Polymer battery pack, with a T-Style connector. This pack includes an integrated balance charge lead with a Deans style T-plug installed for a convenient connection capable of handling high amp rates. While the 3-pin Align/E-Flite style XH balance connector provides compatibility with one of the most common varieties of balance tap connection.
1) DO NOT leave the battery in your model when charging
2) DO NOT leave unattended when charging
3) ALWAYS balance charge the battery
4) ALWAYS use a LiPo charging bag
5) YOU MUST use a Li-Poly specific charger to charge the pack (NiMH or NiCD only chargers WILL NOT WORK!)
6) YOU MUST not over discharge the Li-Poly battery pack
7) READ & UNDERSTAND the instructions carefully before operating this battery
When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in over heated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell) Do not use the battery that has too low a voltage.
Do not expose batteries to sunshine or store/charge batteries at the temperature above 35°C or in a closed car. The high temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging or racing, do not charge the battery until it has cooled completely. Wait about 20 mins, then inspect prior to recharging.Type: Lithium Polymer
Voltage: 11.1V nominal
Connector Type: T-Style Ultra (12 GA Wire)
Balancer Type: Align/E-Flite compatible (XH)
Number of Cells: 3
Recommended Charge Rate: 1C (5A)
Maximum Continuous Discharge: 50C (250A)
Part Number ECP-5117 Battery Chemistry LiPo Battery Voltage 11.1V (3-cell) Capacity mAh 5000mAh Discharge Rate 50C Connector Type Deans (t-type) Type Lithium Polymer Capacity 5000mAh Voltage 11.1V nominal Connector Type T-Style Ultra (12 GA Wire) Balancer Type Align/E-Flite compatible (XH) Number of Cells 3 Weight 369g Configuration 3S1P Dimensions 154x46.5x24mm Recommended Charge Rate 1C (5A) Maximum Continuous Discharge 50C (250A)
- Questions & Answers
- Must be logged in to ask a question.
Sort By:No questions yet. Be the first to ask the question!