Home /
Ecopower "Basher" 4S 14.8V 5000mAh 100C Hard Case Lipo Battery with EC5

Overview

Overview

This EcoPower 4S Hard Case LiPo Battery is your go-to option when it's time pull the trigger wide open, light up the tires and fling some dirt!

Sized for Arrma, Losi and more, this battery features a hard plastic exo-skin that protects the inner cells from the abuse of bashing. The case also features wire slots designed to allow the leads to sit flat, in the event you stack two batteries together for 8S use.

For Arrma vehicles that use the long inboard hook & look strap, you'll find the balance lead and ESC wires spaced apart to allow that strap to secure the batteries without damaging the wires.

EcoPower part #ECP-5119, "Basher" 4S 14.8V 5000mAh 100C Hard Case LiPo Battery with/EC5 Connector

features

Hard plastic case
Stackable design
100C discharge rate
5000mAh of capacity
EC5 connector (compatible with IC5)
Also available as a 3S (ECP-5118)

NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in over heated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell) Do not use the battery that has too low a voltage.

Do not expose batteries to sunshine or store/charge batteries at the temperature above 35°C or in a closed car. The high temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging or racing, do not charge the battery until it has cooled completely. Wait about 20 mins, then inspect prior to recharging.

Specs

Type: Lithium Polymer
Capacity: 5000mAh
Voltage: 14.8V nominal
Connector Type: EC5 Ultra (12GA Wire)
Balancer Type: Align/E-Flite compatible (XH)
Number of Cells: 4
Weight: 420g
Dimensions (WxLxH): 47x139x37mm
Maximum Charge Rate: 2C (8.2A)

IMPORTANT:
1) DO NOT leave the battery in your model when charging
2) DO NOT leave unattended when charging
3) ALWAYS balance charge the battery
4) ALWAYS use a LiPo charging bag
5) YOU MUST use a Li-Poly specific charger to charge the pack (NiMH or NiCD only chargers WILL NOT WORK!)
6) YOU MUST not over discharge the Li-Poly battery pack
7) READ & UNDERSTAND the instructions carefully before operating this battery

Product Videos

Specs

Product Specifications

Part Number	ECP-5119
Battery Chemistry	LiPo
Battery Voltage	14.8V (4-cell)
Capacity mAh	5000
Discharge Rate	100
Connector Type	EC5
Type	Lithium Polymer
Capacity	5000mAh
Voltage	14.8V nominal
Connector Type	EC5 Ultra (12GA Wire)
Balancer Type	Align/E-Flite compatible (XH)
Number of Cells	4
Weight	420g
Dimensions (WxLxH)	47x139x37mm
Maximum Charge Rate	2C (8.2A)
IMPORTANT

Reviews

Be the first to review this product

Questions & Answers

Sort By:

Must be logged in to ask a question.

No questions yet. Be the first to ask the question!

Ecopower "Basher" 4S 14.8V 5000mAh 100C Hard Case Lipo Battery with EC5

Overview

features

Specs

Product Videos

Product Specifications

Recently viewed product(s)

Maclan Extreme Drag Race Graphene Lipo Battery (2S / 200C / 7.4V / 10000mAh) with QS8 Connector